Loading
Search Suggestions: Find Inspiration
Loading
/

SKOPE-connectEYE: Installation

Important Advice

  • Install away from any air grille (fig 1).
  • Install within 100mm of the hinged side of the door (figs 2 & 3) to measure door openings.

Fig 1.

Fig 2.

Fig 3.

Install on a Fridge

  1. Wipe the install area clean using the included alcohol wipe.
  2. Peel off the backing to the adhesive on the EYE.
  3. Place the EYE in the install area. Press firmly for 10 seconds to ensure it is stuck down.

Install on a Freezer

 Adhesion can be difficult if the freezer is at operating temperature.

  1. Peel off the backing to the adhesive on the EYE.
  2. Turn off the freezer. If that’s not practical, temporarily adjust temperature on the surface where you wish to place the EYE:
    • Apply warm water with a towel. Hold for 10 seconds.
    • Quickly wipe dry with a clean paper towel.
  3. Place the EYE on the install area. Press firmly for 10 seconds to ensure it is stuck down.

Note: Only use screws as a last resort or if permanent fixing is desired. Use of the screws may cause irreparable damage to the fridge, or injury to the user, that is not covered by SKOPE. Please contact your fridge manufacturer for advice.